SocketMobile DURASCAN D600 - Factory Reset; Performing a Factory Reset

Factory Reset will restore the D600 to Factory Default settings (congured
as shipped).
Follow the Factory Reset (button) sequence:
1. Power ON the reader.
2. Press and hold the trigger button.
3. Tap the power button once while continuing to press the trigger.
4. Keep holding the trigger button until you hear a beep
(about15 seconds).
When you release the trigger button you will hear 5 conrmation beeps.
The next time you power on the D600, it will take longer to start up. After
it nishes powering on, it will have factory default settings (HID mode).
Note: If you follow this sequence but release the trigger button too early
(before 15 seconds and the beep) the Factory Reset will fail.
13
FACTORY RESET
Tap the power button
1
2