Windows: Connect Windows Device in Basic Mode
In this mode the reader functions and communicates similar to a
keyboard. Therefore, the reader will work with Notes, and any other
application that supports an active cursor.
1. Turn Bluetooth on for your device. Go to Settings > Bluetooth. A
Bluetooth Devices search will begin.
2. Tap Socket D600[xxxxxx] in the list of Devices found. After a few
seconds the “Not Paired” status will change to “Connected” or
“Paired” and the reader blue light will stop blinking and turn solid
blue.
Note: The characters in bracket are the last 6 characters of the Bluetooth
address.
Now you are ready to read RFIDs!
19
To Next Page
Loading...