CREATE THE BUBBLES
1. Fill the Carbonating Bottle with cold water up to the fill line.
WARNING! Do not carbonate anything other than water. Other
liquids can contaminate and clog internal parts, potentially
resulting in excessive pressure, bottle failure during carbonation
and serious injury. Never carbonate after flavoring has been
added.
2. To insert the Carbonating Bottle, make sure that the Carbonating Bottle
rest is angled forward. Please make sure you do not pull the
carbonating tube. WARNING! Never use a Sparkling Water Maker
with a broken carbonating tube. This can cause excessive pressure,
bottle failure and serious injury. Insert the Carbonating Bottle neck into
the Snap-Lock. Push the Carbonating Bottle up and back. The
Snap-Lock will hold the Carbonating Bottle.
3. The carbonating buttons will light up when the Carbonating Bottle is
attached. If the Sparkling Water Maker is not used for 60 seconds, the
lights will turn off. The lights will come on when any button is pressed.
Carbonate, press as follows to get the carbonation level of your choice:
• For 1L Carbonating Bottle: Left button (one drop) for light fizz; Middle
button (two drops) for medium fizz; Right button (three drops) for
strong fizz.
• For 0.5L Carbonating Bottle: Left button (one drop) for medium fizz;
Middle button (two drops) for strong fizz.
4. When the desired level of carbonation is achieved, gently pull the
Carbonating Bottle towards you until it reaches its fully forward
position. This will release the pressure in the Carbonating Bottle and
allow the Carbonating Bottle to be released from the Snap-Lock.
WARNING! Do not remove Carbonating Bottle until after hearing
the sound of excess CO
2
being released. Never force the Carbonating
Bottle out of the Snap-Lock. Always allow the Sparkling Water Maker to
release the Carbonating Bottle. If the Carbonating Bottle does not
immediately release from the Snap-Lock wait a few moments. If it still
does not release, then push the Carbonating Bottle back into the
vertical position and gently pull it towards you again. Attempting to
remove the Carbonating Bottle while it is still pressurized can
cause uncontrolled ejection of the Carbonating Bottle and may
result in serious injury.
CARE
SPARKLING WATER MAKER CARE
• Never use abrasive cleaners or sharp tools to clean. If needed, use a mild liquid dish soap and a soft
damp cloth to gently clean.
• Wipe spills to keep base dry.
•
Do not place in water or wash in a dishwasher, doing so will seriously damage your Sparkling Water
Maker.
CARBONATING BOTTLE CARE
• For Carbonating Bottles which are not "dishwasher safe", to clean, rinse Carbonating Bottles with cold or
lukewarm water. WARNING! Do not expose to heat above 50°C. Never wash or rinse in hot water.
Do not wash in dishwasher.
•
For "dishwasher safe" Carbonating Bottles, to clean, either wash in dishwasher or rinse Carbonating
Bottles with cold or lukewarm water. WARNING! Do not expose to heat above 70°C.
1
3
4
Note: when inserted correctly, there is a
small gap between the bottom of the
Carbonating Bottle and the base. Do not
carbonate if the Carbonating Bottle is
resting on the base, or water will splash out.
1
5
Note: You may see small pieces of ice appear in
the water during carbonation of very cold water.
Any ice created will simply melt.
A
B
C
E
D
To Next Page
Loading...
