EN
1. Start
All fans produced by SODECA, hereinafter the manufacturer, and the full line of accessories, have been manufactured under
the most rigorous standards of quality assurance, systems and production processes.
Their project, testing, manufacture and control structure has been configured in line with EU standards and regulations,
especially as regarding current safety standards.
The materials used in our fans, and the standardised components of which they are made meet the same standards and, when
so required, are backed up by the corresponding quality certificates.
The Original Manual was written in Spanish
The manufacturer reserves the right to make modifications without prior notice
All the documentation in this manual is the property of the manufacturer, and its total or partial reproduction is prohibited.
2. Product Definition
KIT BOXPDS: Pressurisation equipment for stairwells, escape routes and lobbies, compliant with European Standard EN
12101-6.
IMPORTANT: This product is not suitable for use in explosive environments.
FEATURES OF THE KITS
Component
Variable Frequency Inverter
High precision differential pressure probe
Electrical switchboard with magneto-thermal circuit-breakers and mains power cut indicator
Certified battery-powered power source to guarantee supply to the control equipment if there is a mains
power failure
Electronic control for managing alarms maintenance. ModBUS port for connection to BMS (Building
management systems) and Damper based control
3. General Information
• Always check the products received (Fig. 2).
• After unpacking the equipment, it must be checked to make sure that it is not damaged. Damaged products must never
be installed.
• This equipment must not be used for purposes other than those for which it was designed; it must only operate under
the conditions described in this manual.
• In the event of a defect or malfunction, this must be reported to the authorised representative, with a description of the
problem, in order to coordinate its return or possible repair.
• Before starting up the equipment, it is important to ensure that the safety and installation instructions in this document
have been read
4. Transportation, storage and handling
• Always hold the equipment at the points provided for this. Do not lift it by the electrical cables, connection boxes, or the
air inlets or outlets.
• Before installation, store the equipment in a clean, dry place, protected from inclement weather.
5. Safety
• Do not disassemble or modify the equipment. This could negatively affect the equipment or even cause accidents.
• Do not put fingers or any objects into the protective grilles on ducts, inlets or outlets. If this were to occur, immediately
disconnect the equipment's power supply.
• Never use a damaged power cable.
• Do not operate the equipment if it has been forcibly installed on a curved or unstable surface.
• Do not perform equipment inspection or maintenance without first checking the following:
o That the equipment has been disconnected from the electrical supply.
o That all its components are at rest.
• The equipment must not be operated unless it has been properly installed and the inlets and outlets have been
protected, if necessary.
To Next Page
Loading...
