Wire EDM Machine Operation Table Of Contents
Copyright June, 98 Sodick Inc.
CENTERFIND OF A HOLE OR SHAPE 14-8
CORNER FIND ROUTINE 14-10
CLEARING THE MEMORY 14-11
CHANGING THE FILENAME 14-11
TYPING NEW PROGRAMS INTO MEMORY 14-11
SAVING PROGRAMS FROM MEMORY TO USER DISK (WITHOUT HARD DRIVE)
14-11
SAVING PROGRAMS FROM MEMORY TO USER DISK (WITH HARD DRIVE) 14-12
EDITING USER DISK OR HARD DRIVE DIRECTLY 14-12
SAVING PROGRAMS FROM MEMORY TO HARD DRIVE 14-13
MAKING A COPY OF A PROGRAM 14-13
LOADING PROGRAMS FROM USER DISK TO MEMORY (WITHOUT HARD DRIVE)
14-13
LOADING PROGRAMS FROM USER DISK TO MEMORY (WITH A HARD DRIVE)14-
14
LOADING PROGRAMS FROM HARD DRIVE TO MEMORY 14-14
SAVING PROGRAMS FROM HARD DRIVE TO USER DISK 14-14
SAVING PROGRAMS FROM USER DISK TO HARD DRIVE 14-15
DELETING PROGRAMS FROM MEMORY (WITH OR WITHOUT HARD DRIVE)14-
15
DELETING PROGRAMS FROM USER DISK (WITHOUT HARD DRIVE) 14-16
DELETING PROGRAMS FROM USER DISK (WITH HARD DRIVE) 14-16
DELETING PROGRAMS FROM HARD DRIVE 14-16
COPYING A USER DISK TO ANOTHER DISK (WITHOUT HARD DRIVE) 14-17
COPY A USER DISK TO HARD DRIVE OR HARD DRIVE TO A USER DISK 14-17
USING THE EDITOR 14-17
COPYING A SYSTEM DISK (WITHOUT HARD DRIVE) 14-19
INITIALIZING A NEW USER DISKETTE 14-20
RUNNING PROGRAMS FROM THE ACTIVE MEMORY 14-21
RUNNING PROGRAMS FROM DISK (WITHOUT HARD DRIVE) 14-21
DRAWING GRAPHICS 14-21
CHANGING POWER SETTINGS WHILE MACHINING 14-22
SWITCHING BETWEEN MACHINE CONTROL AND “APT” 14-22
COPING FROM DRIVE 1 TO DRIVE 2 (WITH HARDDRIVE AND 2 FLOPPY DRIVES)
14-23
COPYING ALL “APT” FILES FROM THE FLOPPY TO THE HARDDRIVE 14-23
COPY ALL PART PROGRAM FILES FROM THE HARDDRIVE TO FLOPPY DRIVE
# 1 14-24
CHAPTER 15 CRT SCREENS 15-1
SCREEN DEFAULT PARAMETERS 15-1
MAL-MDI SCREEN 15-3
MAL SCREEN 15-3
EDIT, GRAPH SCREEN 15-7
EDIT, GRAPH, SCRN FLAG INPUT SCREEN 15-9
DISPLAY SCREEN 15-11
SET SCREEN #1 15-13
SET SCREEN #2 (ROLL UP KEY) 15-17
SET, TRAVEL SCREEN #1 15-19
To Next Page
Loading...