Wire EDM Machine Operation Chapter 9
Copyright November, 98 Page 9-5 Sodick Inc.
N010 G92 X.3 Y-.2 (SET PROGRAM ZERO)
N015 G90 (SELECT ABSOLUTE MODE)
N020 C411 (SELECT CONDITION FOR ROUGH PASS)
N021T91 (AUTO WIRE THREAD)
N025 G42 H082 (.0082" OFFSET TO THE RIGHT)
N026 T88 (SUBMERSE FOR SUBMERSIBLE MACHINES ONLY)
N027 T84 (TURN ON HIGH PRESSURE FLUSHING PUMP)
N030 M98 P1000 (JUMP TO N1000 AND MAKE ROUGHING PASS)
N033 T85 (TURN OFF HIGH PRESSURE PUMP)
N035 C621 (SELECT CONDITION FOR FIRST TRIM PASS)
N040 G41 H056 (SEL. COMP LEFT & .0056 OFFSET, 1ST TRIM PASS)
N045 M98 P2000 (JUMP TO N2000 AND MAKE FIRST TRIM PASS)
N050 C651 (SELECT CONDITION FOR SECOND TRIM PASS)
N055 G42 H053 (SET .0053 OFFSET TO RIGHT SECOND CUT)
N058 M98 P1000 (JUMP TO N1000 AND FOR 2ND TRIM CUT)
N060 M00 (STOP TO APPLY MAGNETS FOR CUTOFF)
N065 C411 (SELECT ROUGHING CONDITION FOR CUTOFF)
N066 T84 (TURN ON HIGH PRESSURE FLUSHING PUMP)
N070 G01 X.3 (CUT OFF TO POINT 17)
N075 Y-.2 (MOVE BACK TO START POINT)
N080 M02 (END OF MAIN PROGRAM)
(COUNTER CLOCKWISE SUB ROUTINE)
N1000 G01 Y0 (MOVE TO POINT 2)
N1005 X.9 (MOVE TO POINT 3)
N1010 G03 X1. Y.1 J.1 (MOVE TO POINT 4)
N1015 G01 Y.4 (MOVE TO POINT 5)
N1020 G03 X.9 Y.5 I-.1 (MOVE TO POINT 6)
N1025 G01 X.6 (MOVE TO POINT 7)
N1030 G02 X.5 Y.6 J.1 (MOVE TO POINT 8)
N1035 G01 Y.9 (MOVE TO POINT 9)
N1040 G03 X.4 Y1. I-.1 (MOVE TO POINT 10)
N1045 G01 X.1 (MOVE TO POINT 11)
N1050 G03 X0 Y.9 J-.1 (MOVE TO POINT 12)
N1055 G01 Y.1 (MOVE TO POINT 13)
N1060 G03 X.1 Y0 I.1 (MOVE TO POINT 14)
N1065 G01 X.2 (MOVE TO POINT 15)
N1070 G40 Y-.02 (CANCEL OFFSET AND MOVE TO POINT 16)
N1075 M99 (END OF SUB ROUTINE, JUMP BACK TO MAIN)
(CLOCKWISE SUB ROUTINE)
N2000 G01 Y0 (MOVE TO POINT 15)
N2005 X.1 (MOVE TO POINT 14)
N2010 G02 X0 Y.1 J.1 (MOVE TO POINT 13)
N2015 G01 Y.9 (MOVE TO POINT 12)
N2020 G02 X.1 Y1. I.1 (MOVE TO POINT 11)
To Next Page
Loading...