Need help?Do you have a question about the Soehnle 2790 and is the answer not in the manual?
General| Display Type | LCD |
|---|---|
| Auto Shut-off | Yes |
| Batteries Required | Yes |
| Battery Type | AAA |
| Number of Batteries Supported | 2 |
| Auto Power Off | Yes |
| Overload Indicator | Yes |
| Measurement Units | kg, lb |
| Material | Glass |
Press and hold →0←, then press F for 3 seconds. Press →0← twice.
Press →0← once, then →T← once. Finally, hold →0← and press →0←.
Assignable to F key. Enables counting mode. Reference items are displayed and can be incremented.
Assignable to F key. Freezes displayed value. Supports 6 modes settable in User Mode.
Displays the current software version.
Sets backlighting behavior: Off, on for 30s, or always on.
Configures automatic switch-off time in minutes.
Sets the empty value as a percentage of maximum load.
Assigns functions like Hold, Count, or Unit switch to the F key.
Sets various hold modes: Inactive, Standstill, Max. value, Slave counter.
Selects filter speed: Very rapid, Rapid, Normal, Slow, Very slow.
Sets printer type: No printer, Strip, Label TSP800, or IT.
Specifies IT connection details, including an email address.
Enables or disables external alibi memory.
Describes zeroing behavior and potential issues with zero range.
Indicates the part weight is too small for the scale's capacity.
Indicates the zero limit has been exceeded or undershot.
Indicates that taring is not possible with current values.
Indicates printing is not allowed due to overload/underload.
Indicates the switch to lbs mode is deactivated.
For other errors, contact SOEHNLE service.
To Next Page