EasyManua.ls Logo

Sofirn HS20 - Page 3

Sofirn HS20
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation Instructions
The throw or flood can be operated independently, the operation is the same. The switch controls all
headlamp functions as follows:
From OFF
Click Throw button to turn on Throw mode. Press and hold to select modes: Low/Med/High. One click to
turn off.
Double click Throw button to turn on Turbo, click to turn off
Triple fast clicks to activate lockout, another triple-click to cancel lock-out.
Press and hold Throw button to turn on Eco, keep holding for more than 1 second, it goes to standard
mode: Low-Med-High, or click to turn off.
From ON
click the Throw button to turn off.
Double clicks to Turbo, another click returns to the previously mode.
Triple clicks to cycle through Throw - Flood - Throw+Flood
Long press the Throw button, you can cycle through Low - Medium - High
Troubleshooting and Maintenance
Disassembling the sealed head can damage the headlamp and voids the warranty.
Sofirn Ltd. recommends using high-quality brand batteries. Damage by battery leakage voids the
warranty.
Remove the battery if the headlamp will not be used for an extended period of time.
To prevent self-discharge or accidental activation during storage or transportation, unscrew the tailcap
by half a turn or remove the battery.
Every 6 months threads should be wiped with a clean cloth followed by a thin layer of siliconegrease.
To maintain a proper level of waterproof, replace worn-out o-rings with an approved spare.
Troubleshooting: Clean battery contacts regularly as dirty contacts may impair the performance of the
headlamp. If you experience problems (flicker, shine intermittently or failure turn on) the following root
causes and solutions should be tried:
Reason A: The battery needs a replacement.
Solution: Replace the battery with an approved type of a fully charged battery.
Reason B: Threads, PCB board contact or other contacts are dirty.
Solutions: Please clean the contact points with a cotton swab soaked in rubbing alcohol.
Reason C: The headlamp will not turn on upon first use.
Solution: Please do not forget to remove the insulation sticker from the battery on first use.
If the above methods do not work please refer to the warranty policy before contacting your authorized
distributor.
Sofirn Limited:
Tel:
+86-755-23440047
Fax: +86-755-23440141
Web:
www.sofirnlight.com
E-mail:
us@sofirnlight.com
eu@sofirnlight.com wholesale@sofirn.cn
Please contact us if you have any questions.
If your product is defective please contact us for replacement within warranty period.
Manufacturer: Shenzhenshi Jinba Technology Co.,Ltd
Address: 1/F to 9/F, 1st Building, NO.110 Tenglong Industrial Center, Guanlan Street, Longhua New District,

Related product manuals