BLF LT1 Manual
Please do these before using!
Unscrew the body and remove the insulation paper!
If you have any questions, please contact us
Website: www.sofirnlight.com; www.sofirn.cn;
https://sofirn.aliexpress.com; https://sofirn.en.alibaba.com
Email: us@sofirnlight.com(amazon); eu@sofirnlight.com(amazon),
wholesale@sofirn.cn
The product uses copyrighted code released under the GNU Public License v3 (GPLv3).
To know about the exact source code used in the product, please go to
https://tiny.cc/TKAnduril
Specifications
Emitters: 8 x Samsung LH351D(4 x 5000K 90CRI + 4 x 2700K 90CRI)
Luminous Flux: ca. 700 lm
Firmware: The LT1 uses open source software called Andúril, distributed under the terms of the
GPL v3. The source code is available from http://tiny.cc/TKAnduril
User interfaces:
By default the LT1 is set to use the SMOOTH RAMPING mode. STEPPED RAMPING mode is
available if you prefer discrete brightness steps.
MUGGLE mode simplifies the LT1’s UI & features to just on/off and smooth ramping. MUGGLE
mode also reduces the maximum output level produced by the LT1 to reduce self heating.
Electronic LOCKOUT mode keeps the LT1 from being turned on accidentally. LOCKOUT mode also
provides a momentary low light when the button is pushed.
Other functions:
Battery check, sunset, beacon, tactical strobe, party strobe, bike flasher, candlelight, & lightning
To Next Page
Need help?
General
