Solution: uncrew the body and remove the round insulating paper, screw back and try click again.
-why the item flashes improperly?
Solution: screw the tube, clean the contacts with clean cloth with alcohol. Screw back tightly again.
Usage and Maintenance:
※ Disassembling the sealed head can cause damage to the light and void the warranty.
※ Sofirn recommends using high-quality batteries. If the flashlight will not be used for an
extended period, please remove the battery, or the flashlight might be damaged by the electrolyte
leakage or battery explosion.
※ Please unscrew the tail cap one-half turn or take out the battery to prevent accidental
activation during storage or transportation.
※ please use cleaning cloth to clean the thread every 6 months, and it will be better to use
silicone grease to oil thread.
※ Long-tern usage can result in O-ring wear. To maintain a proper water seal, replace the ring
with an approved spare.
※ Periodic cleaning of the battery contacts improves the flashlight ’ s performance as dirty
contacts may cause the flashlight to flicker, shine intermittently or even fail to illuminate for the
following reasons:
Reason A: The battery needs replacement.
Solution: please replace battery. Please confirm the correct installation Reason B: The threads, PCB
board contact or other contacts are dirty.
Solutions: please clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods do not work please refer to the warranty policy before contacting your
authorized distributor.
Sofirn Limited:
Tel: +86-755-23440047 Fax:+86-755-23440141
Web: www.sofirnlight.com
Email: us@sofirnlight.com; eu@sofirnlight.com; wholesale@sofirn.cn
Please contact us if you have any questions.
If your product is defective please contact us for refund or replacement within warranty.
Manufacturer: Shenzhenshi Jinba Technology Co.,Ltd
Address: 1/F to 9/F, 1st Building, NO.110 Tenglong Industrial Center, Guanlan Street, Longhua New
District, Shenzhen 518000, China
To Previous Page
Loading...
