Battery Installation
Before first use, please unscrew the flashlight and remove the insulating sticker. If the
battery needs to be replaced, please make sure that the positive end of the new battery
faces the flashlight’s head when you put the battery in.
Battery Level Indicator
The indicator shows the power status for 5 seconds after you turn on the light.
Green = remaining battery power is on 75%-100%.
Flashing Green = remaining battery power is on 50%-75%.
Red = remaining battery power is on 25%-50%
Flashing Red = critical power (less than 25%), please replace or recharge
battery as soon as possible.
Charging
SC33 offers a USB type-C charging port for convenient charging. It takes
approximately 2.5 hours to fully charge the flashlight with a 5V/2A charger (not
included). While charging, the indicator flashes in red. It turns green when it's fully
charged.
Operation Instructions
STEPPED RAMPING:
ON/OFF: One-click the switch to turn the light on/off.
CHANGE BRIGHTNESS LEVEL: When the flashlight is on, press and hold the
switch and it will start from the present brightness level, automatically cycle through
Eco, Low, Medium, and High. The mode is selected when the switch has been
released. (Please note: moonlight, turbo and strobe modes are not in the automatic
cycle).
DIRECT ACCESS TO TURBO MODE: When the flashlight is on/off (not in lock
mode), quickly double-click the switch to activate Turbo mode. Double-click again to
cycle Moonlight-Turbo.
DIRECT ACCESS TO STROBE MODE: When the flashlight is on/off (not in lock
mode), quickly triple-click the switch to enter into Strobe. Then triple-click the switch
to cycle through Strobe-SOS-Beacon, one-click the switch to return to previously
used mode.
LOCK/UNLOCK: When the flashlight is off, 4 fast clicks on the switch to lock the
To Next Page
Loading...
