Specifications
Emitter: white light led + UV light led
Battery options: 2x Alkaline AAA batteries, 2x Ni-MH AAA batteries
Operating voltage: 1.8V – 3V
Boost driver
Dimension: 133mm (length) × 15mm (head diameter)
Beam angle: 123 degrees
Weight: 25 grams (without battery)
Flashlight body: Aerospace grade 6061 grade aluminum alloy
Toughened glass lens
Water resistance: IP68 (not for diving)
Mode Memory: While on lighting mode, the flashlight memorizes the last
brightness level used in the general lighting modes.
Reverse polarity protection from improper battery installation
The flashlight steps down automatically or blinks when the battery is low.
When the battery is low, brightness won't have a conspicuous change after you
switch to other brighter or dimmer modes.
The flashlight is compatible with batteries of 86mm long to 91mm long. There
might be a rattling when you use some shorter batteries. Don't worry, it does not
affect use.
Battery Installation
Before first use, please unscrew the flashlight and remove the insulating film. If the
batteries need to be replaced, make sure that the positive end of the new batteries face
the flashlight head when you put it in.
IP68 (up to 2 meter under water, not for diving)
The above mentioned parameters are based on tests according to international
flashlight testing standards (ANSI/NEMA FL1) using 2x Alkaline AAA batteries.
Results may vary with different battery or under different environmental
conditions.
To Next Page
Loading...
