Need help?Do you have a question about the Softub T300 and is the answer not in the manual?
Safely open the Softub box using a hammer claw, not a razor knife, to begin assembly.
Identify all included items and position cover straps in an "X" pattern for proper attachment.
Verify strap placement and connect the power unit to the tub, ensuring snug, thread-free connections.
Flush the hose before filling the tub. Smooth liner wrinkles once water reaches approximately 2 inches.
Install the filter, fill the tub 2 inches above the highest jet, and check for leaks before plugging in.
Perform final leak checks, install covers, check chemical levels, and operate the air control.
Set the desired water temperature and secure the cover; the tub heats at 1-1.5 degrees per hour.
To Next Page
General
