Need help?Do you have a question about the Softub T140 and is the answer not in the manual?
General| Model | T140 |
|---|---|
| Category | Hot Tub |
| Water Capacity | 140 gallons |
| Seating Capacity | 1-2 persons |
| Dimensions | 60" outside diameter |
| Height | 24 inches |
| Heating System | Hydromate® heat recovery system |
Open the box carefully without a razor knife, using a hammer's claw to tear flaps open.
Check all included items. Ensure the filter is installed, leaving it on the tub wall if pre-installed.
Place cover straps in an 'X' pattern, buckle facing up, with plumbing connectors between them for secure attachment.
Check strap placement under the tub and dry-fit the cover. Align power unit connectors with tub connectors.
Twist connectors clockwise until snug, ensuring no threads show. Connect the light connector.
Run the hose for 2-3 minutes to clear debris before starting to fill the tub with water.
After adding about 2 inches of water, smooth out liner wrinkles by hand, tucking edges to alleviate them.
Ensure filter is installed and soaked. Fill tub to 2 inches above the highest jet. Do not plug in the tub yet.
Check tub connections for leaks and tighten if needed. Plug the tub in now.
While running, check for leaks and tighten connectors. Install the foam and vinyl connector covers.
Check water chemistry, adjust as needed. Run air control counter-clockwise for 15 min, then close it. Put lid on.
Set the tub to your desired temperature and lock the cover. The tub heats at 1 to 1.5 degrees per hour.
To Next Page
