Trademarks
All names and products mentioned below are registered trademarks of their respective companies.
Introduction
Thank you for purchasing our Mobile Disk Enclosure, this manual contains information of installation
and device capabilities. Please read this manual thoroughly before you start in and retain it for future
reference.
The mobile disk is an USB 2.0 interface enclosure. It’s easy to mount an existing 2.5” hard disk inside
by DIY and implement a high performance external backup storage device. It works on cross-platform
flexibly between PC and Mac systems. You can store your digital photos, MP3 files, large graphics
works, and backup important documents for your digital life quickly and easily.
Product features:
• USB 2.0 interface, support up to 480 Mbps high speed data transfer rates
• Backward compatible with USB 1.1 specification
• Suit to 2.5” hard disk drive application
• Plug-n-Play & hot swappable
• Elegant, firm, aluminum housing, perfect for the mobile professional
System requirements
IBM
®
PC or Macintosh
®
computer with one free USB2.0 port*.
Supports Windows
®
98SE**、Windows
®
ME、Windows
®
2000、Windows
®
XP.
Supports Mac
™
OS 9.x**and 10.0.X or later.
Requires 2.5” hard drive to be installed before using Mobile Disk box.
* The Mobile Disk can work at both USB 1.1 and USB 2.0 port. To access a hi-speed data transfer rate,
you must connect to an USB 2.0 Hi-speed port.
** If you are using Windows
®
98SE、Mac
™
OS 8.x & 9.x one time installation of the driver is required.
Package contents
Please check following items that should be in your package, if any of items are short supplied or
damaged, please inform to our supporting center or your local dealer.
Mobile Disk enclosure (without hard drive)
USB cable (with an extra USB auxiliary power cord)
Driver disc with manual
Soft carry-bag
Screwdriver for DIY
Install 2.5” Hard drive
Before using Mobile Disk Enclosure
Touch exposed metal casing of your computer's power supply or its circuit board before you handle
the mobile disk to prevent damage from static discharge.
Handle IDE PCB board by the plastic cap to avoid touching the electronic components.
To avoid damage to your hard drive, please handle with caution. Do not shake or drop the hard drive.
- 2 -
To Next Page
Loading...