Need help?Do you have a question about the Solace i Series and is the answer not in the manual?
General| Engine Start | Yes |
|---|---|
| Engine Kill | Yes |
| Trunk Release | Yes |
| Door Lock/Unlock | Yes |
| Security System | Yes |
| Compatibility | Most vehicles |
| Remote Range | Up to 3000 feet |
| Smartphone Control | Yes (with optional module) |
Visual overview of main connectors CN1 through CN5 and their basic functions.
Visual overview of specialized connectors CN6, CN8, and CN9.
Diagram and information for the optional relay pack.
Steps for entering program mode and selecting menus.
Details on transmitter learning, tach learning, and changing settings.
Procedure to reset all system programming to factory defaults.
Relay diagrams for negative one-wire resistance door locks.
Relay diagrams for positive one-wire resistance door locks.
Continuation of relay diagrams for negative type door locks.
Continuation of relay diagrams for positive type door locks.
Relay diagrams for reverse polarity type door locks.
Relay diagrams for adding after-market door lock actuators.
Diagram for switching a negative start output to a positive start output.
Diagram for switching a negative ignition output to a positive ignition output.
Diagram for converting a negative accessory output to positive.
Diagram for converting a negative output to a positive output.
Diagram for converting a positive output to a negative output.
Diagram showing relay use for adding resistance via ground.
Diagram for isolating wires, especially for multiplex systems.
Diagram illustrating relay use to connect two wires.
Diagram for opening or cutting a wire using a relay.
Diagram for implementing starter kill or anti-grind functionality.
Diagram for providing high current ground or positive connections.
Explanation of diode symbol and current flow.
Diagram for switching one negative wire to two isolated negative wires.
Diagram for switching one positive wire to two isolated positive wires.
Diagrams for monitoring multiple positive and negative door pins.
Diagrams for isolating negative and positive falsing door pin wires.
Procedures for testing 12V constant, starter positive, and accessory positive wires.
Procedures for testing ignition, park lights, and horn wires.
Procedure for testing OEM alarm disarm and rearm signals.
Procedures for testing disarm, rearm, and tachometer signals.
Procedures for testing brake switch and park brake wires.
Procedures for testing trunk release and door pin wires.
Procedure for testing the wait to start or glow plug light wire.
Procedures for testing hood, auxiliary, lock, and unlock wires.
Testing procedures for integrating bypass modules.
To Next Page
