Solamiser User Manual
MODE 3 – DIVERTING TO IMMERSION HEATER
When producing single pulses Solamiser is detecting that
very little energy is flowing back to the mains. Nearly all
excess electricity being generated by your solar panels is
being used by both your house and your immersion
heater.
Variable amounts of energy are diverted to your
immersion heater to maintain this balanced state. For
example, if you turn on the TV, the amount of energy
going to the immersion heater will reduce by the amount
used by the TV. If the sun goes behind a cloud
Solamiser will reduce power to the immersion heater to
maintain balance.
The pulse rate of the LED in MODE 3 reflects the amount
of energy being diverted to the immersion heater i.e.
approximately 1 pulse per Wh.
20
To Next Page
Loading...