Solamiser User Manual
MOUNTING SOLAMISER
a) Using the 4 Fixing holes and screws provided,
Install Solamiser on a vertical surface as close as
possible to the mains consumer unit.
b) Ensure that there is at least 150 mm of clearance
both above and below Solamiser and 50 mm of
clearance to the left of Solamiser to facilitate
plugging in the current sensor.
c) Turn off and isolate the mains power switch at the
front of the consumer unit.
d) Mount Solamiser where the ambient temperature
will not exceed 30° C. The black heat sink on the
front of the unit must not be obstructed. This is to
allow free airflow through its fins to prevent power
devices from overheating.
4
To Next Page
Loading...