SolarEdge Wi-Fi Kit Quick Installation Guide
MAN-01-00166-1.1
Wi-Fi Configuration
1 Verify that the inverter ON/OFF switch is OFF.
2 Turn ON the AC to the inverter.
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated
wires when the inverter cover is removed.
3 Press the Enter button for at least 5 seconds, and enter the
password (12312312).
4 Select Communication Î Server Î Wi-Fi.
5 Select Communication Î Wi-Fi Conf
6 Do one of the following:
If your router supports WPS mode, you can automatically
connect without entering a password (use either the LCD light
button or the internal user buttons):
a. Select Wi-Fi Conf Î WPS mode.
b. Push the WPS button on your router and hold until a LED
lights up (refer to your router manual).
c. Check that the message Connected is displayed on the
inverter LCD screen.
Otherwise, to connect to a specific network from a list (use the
internal user buttons):
a. Select Wi-Fi Conf Î Scan Networks.
b. Select the required network from the list of networks.
c. If required, enter the security key (up to 20 characters) and
long-press the Enter button.
The system starts the connection process. Connection time
may take up to 30sec, after which the message Connected
is displayed on the LCD for 5 seconds.
7 Press Esc to exit the Setup mode.
To Next Page
Loading...