AlphaStat-Plus Power Up.
Before you connect the power;
1. Read safety instructions, warnings and limit of liability before proceeding.
2. Complete all the installation and securely mount the AlphaStat-Plus.
3. Power outlet socket to be installed by a qualified electrician.
4. SolaStat-Rly to be installed by qualified person.
5. Ensure suitable over-current protection and RCD Protection for the AlphaStat-Plus is in place.
6. There is no water, metal shavings or other electrical hazards to contaminate the plug, socket and
surrounding environment.
7. The mechanical Hot Water Thermostat for the Electric Element MUST be installed in series with the
element and MUST be set higher than the temperature of all the adjustable values for the HWC
Control Modes to operate correctly. The Hot Water Thermostat for the Electric Element is only used
as a fail safe feature and in normal operation will never operate. We recommend setting the Hot
Water Thermostat to the Maximum Temperature. Refer to the Trouble Shooting Guide for errors that
an be caused by incorrect Hot Water Thermostat settings.
Only then;
Plug it in and turn it on.
What You Should See.
The first thing you should see after power up is;
1. A digital readout of the ‘TANK’ temperature in degrees Celsius.
2. On the left the ‘PWR’ light and the ‘TANK’ light shouuld be on.
3. On the right the lights will be on depending on how the hot water system is operating.
The AlphaStat-Plus is now installed and should be working. It would be best to observe some hot water
heating cycles but this will depend on the temperatures in the system. Check all functions are working
correctly before leaving the installation.
Note 1. See User Guide for explanation of display and status lights.
Note 2. See “Trouble shooting” section if the system is not working correctly.
Note on BioSafe After Power-up.
When the AlphaStat-Plus is turned on either for the first time or after a power failure the BioSafe 72 hour
timer starts from power up (unless the temperature in the tank is greater than the BioSafe Temperature). All
timers are approximate only.
19.08-10
To Next Page
Loading...