11
4 Mechanical Installation
The meter is designed to be installed on the 35 mm DIN rail inside the power distribution
box.
WARNING!
• Only the qualified personnel can perform the mechanical installation following local
standards and requirements.
• Before installation, make sure you have cut off the power supply for the system.
NOTICE!
• Keep the installation site dry, clean, and easy for ventilation and heat dissipation.
Procedure
After connecting the cables based on the wiring diagrams, mount the meter onto the
35mm DIN rail, and then clip it to the rail with strength.
Figure 4-1 Mounting the meter
To Next Page
Loading...