2
DANGER!
Lethal danger from electrical shock due to the inverter
• Only operate the inverter when it is technically faultless. Otherwise, electric shock or
fire may occur.
• Do not open the enclosure in any case without authorization from SolaX.
Unauthorized opening will void the warranty and cause lethal danger or serious
injury due to electric shock.
DANGER!
Lethal danger from electrical shock due to the PV
• When exposed to sunlight, high DC voltage will be generated by PV modules. Death
or lethal injuries will occur due to electric shock.
• Never touch the positive or negative pole of PV connecting device. Touching both of
them at the same time is prohibited as well.
• Do not ground the positive or negative pole of the PV modules.
• Only qualified personnel can perform the wiring of the PV panels.
WARNING!
Risk of personnel injury or inverter damage
• During operation, do not touch any parts other than DC switch, LCD panel and the
enclosure lid of the inverter.
• Never connect or disconnect the AC and DC connectors when the inverter is
running.
• Turn off the AC and DC power and disconnect them from the inverter, wait for 5
minutes to fully discharge the voltage before attempting any maintenance, cleaning
or working on any circuits connected.
• Make sure that the input DC voltage ≤ Maximum DC input voltage of the inverter.
Overvoltage may cause permanent damage to the inverter, which is NOT covered by
the warranty.
CAUTION!
• Keep children away from the inverter.
• Pay attention to the weight of the inverter. Personal injuries may be caused if not
handled properly.
NOTICE!
• If an external RCD is required by local regulations, check which type of RCD is
required for relevant electric codes. It is recommended to use a Type-A RCD with
the value of 300 mA.
• All the product labels and nameplate on the inverter shall be maintained clearly
visible.
ENGLISH
To Next Page
Loading...
