To Next PageTo Next PageWhat to do if SolaX Power Inverter displays no output voltage on the remote monitor?
This is caused by the output switch tripping. Check if the DC switch is damaged, and if it isn't, switch it to the ON position.
What to do if SolaX Power Inverter displays PV Strings Reverse?
If your SolaX Power Inverter shows 'PV Strings Reverse', it means the PV string cables were connected incorrectly during installation. Check the PV string cables and reconnect them correctly if they are reversed.
What causes EEPROM Fault in SolaX Power X3-30K-TL?
The EEPROM Fault in your SolaX Power Inverter is caused by damaged EEPROM Component. Replace the monitoring board.
General| Model | X3-30K-TL |
|---|---|
| Start Voltage | 200V |
| Max. Input Current per MPPT | 30A |
| AC Output Frequency | 50/60Hz |
| THDi | <3% |
| Protection Degree | IP66 |
| Cooling Method | Smart Cooling |
| Weight | 38kg |
| Rated Power | 30kW |
| MPPT Range | 200-1000V |
| Max. AC Power | 30000W |
| AC Output Voltage | 230V |
| Frequency Range | 50/60Hz |
| Operating Temperature Range | -25°C to +60°C |
| Communication | WiFi/GPRS |
| Number of MPPTs | 3 |
| Number of MPP Trackers | 3 |
Step-by-step guide for mounting.
Procedure for grounding the inverter.
Steps to connect AC power cables.
How to connect the DC input from PV strings.
Steps to start the inverter.
Procedures for safely shutting down.
Common alarms, causes, and solutions.
Technical parameters for input and output of 10K/12K models.
Technical parameters for input and output of 20K/30K models.
