11
In order to prevent accidents and injury, please use it in time.
Telescopic handle
Open the handle switch outward (FIG 13) and make it in loose state. Then the handle
drawtube will draw back down (FIG 13). Buckle up the handle switch after the handle
drawtube draw back in place (FIG 14).
Controller
Controller is fixed in the rear cover and it receives the signal from the control panel and transfers
the signal to motor, brake and bulb.
Notice：Do not store the controller in the moisture environment. If the controller has
been affected by moisture, make sure to dry it before operation.
Brake
S3021 install the electromagnetic brake and it can not brake by manual. You can raise the
headstock to move the scooter or pull the scooter after fold.
Motor/Transmission component
To Next Page
Loading...
Need help?
General
