Solax X1-1.1-S-N - Operation Mode

checking if PV array has enough power to
The corresponding state of the inverter shows as right. “ “
The corresponding state of the inverter shows as right. “ “
Under this mode, X1 series inverters convert PV array’s DC into AC and feed back
into grid.
The corresponding state of the inverter shows as right. “ “
If any fault/error occurs, the inverter will stop delivering power until the fault/error
is cleared. Some fault/error will auto recover, and some may need manual restart.
If inverter passed load-dump test and no error/fault occurs, start checking to
deliver power.
feedback into grid.
Operation Mode
[Waiting Mode]
[Checking Mode]
[Fault Mode]
It is normal that the inverter decreases the power output in
the condition of thermal protection, but if this phenomenon
occurs frequently, you need to check the heatsink, or
consider putting the inverter in the place where have better
air ow. If output power decreases caused by electrical,
please ask for professional supports.
Euro - Efficiency
95.5％
97.1％
99.9％ 99.9％99.9％
96.5％96％
97.1％97.1％
YES
YES
YES
YES
YES
Max.Efficiency
Over Voltage Protection
Over Current Protection
DC isolation Impedance
Monitoring
MPPT Efficiency
Safety & Protection
Ground Fault Current
Monitoring
DC injection Monitoring
Protective Class
Net Dimension(W/H/D)
Wall-mounted
-20℃~ +60℃(derating at 45℃)
248*350*124mm
7kg
-20℃~ +60℃
0％~95％，no condensation
＜2000m
IP 65 (for outdoor use)
Transformerless
0W
＜10W
Natural Cooling
＜30dB
RS485/WiFi(optional)/USB/DRM
5years(10 years optional)
Ⅱ / Ⅲ
Net Weight
Storage Temperature
Storage/Operation
Relative Humidity
Altitude
Installation
Operating Temperature
Range
Protection Level
Isolation Type
Night-time Consumption
Operating Loss
Cooling
Noise Level
Communication Interface
Standard Warranty
Pollution degree
Over voltage range(PV/AC)




Ⅱ
12
13
X1-1.1-S-D
X1-1.1-S-N
X1-1.5-S-D
X1-1.5-S-N
X1-2.0-S-D
X1-2.0-S-N
Model
X1-2.0-S-D
X1-2.0-S-N
X1-1.1-S-D
X1-1.1-S-N
X1-1.5-S-D
X1-1.5-S-N
Model
4. Technical data