Solax X3 series Quick Installation Guide

X3 Series4KW-10KW
PVConnection
12AWG
-Align the halves connectors
cable size: 12AWG
trip length
X3 Series 4.0KW-10.0KW
X3 series inverter X 1
Bracket X 1
DC connector X 4
AC connector X 1
Expansion tube X 4
Expansion screw X 4
Earth terminal X 1
Product manual X 1
Warranty card X 1
Quick installation guide
X 1
Meter( Optional )
Pocket Lan( Optional )
Pocket WiFi( Optional )
DC pin contact
(2*positive, 2*negative)
Waterproof connector
with RJ45 X 2
Packing List
Inverter Installation
- Mark the position of four holes
- Drill holes with φ6 drill.
- Depth: at least 50mm.
- Tighten the expansion tubes.
- Screw the expansion screws.
- Match the inverter with the bracket.
positive DC
pin contact
male plug
negative DC
pin contact
clamp contact
nut
female plug
tight nut
cable
Inverter
PV array
PV1
PV2
+
-
+
-
+
-
+
-
+
-
Note!
The PV connection mode in this box
is not allowed!
×
Note: Please refer to the appropriate instruction manual for the usage
of Pocket WIFI and Pocket LAN

Solax X3 series Specifications

General

Type	Hybrid Inverter
Protection Rating	IP65
Output Frequency	50 Hz / 60 Hz
Communication Interfaces	WiFi, Ethernet, RS485
Output Voltage	230V
Operating Temperature	-25°C to 60°C