Solaxx Resilience E Series - Low Salt Error Troubleshooting; Insufficient Salt Levels; Scale Build-up in Cartridge; Air Bubbles in Salinity Sensor (Low Salt)

LOW SALT
LED LOW SALT Turns On when:
Measured water salinity levels are below 2400 ppm
Possible Causes What to do
Not enough salt in pool water
Manually check the salinity of the pool water with a stick. If needed,
add salt according to the salinity table in the installation manual
Scale build-up inside the cartridge
Visually inspect the cartridge for lime-scale. Clean blades if
necessary refer to relevant chapter in manual or appropriate
YouTube video
Air bubbles in the salinity sensor See NO FLOW slide
Other If none of the above resolves the problem replace cartridge
6