CHLORINE ADJUSTMENT
SALT REQUIREMENT
The best salt is a food-quality granulated salt, a 99.9% pure salt or solar salt. These types of salt should be purchased from a pool store and are designed for use with chlorine
generators.
Do not use rock salt, iodized salt or salt with anti-caking additives. Do not use salt with more than 1% yellow prussiate of soda.
Salt Table: Amount of salt needed to achieve 3000 ppm level in your pool.
The optimum salt level is between 3000-4000 ppm. Use the chart above to determine the amount of salt for your pool. The column on the left is the amount of water in your pool.
The column on the top is the current salt level measured in your pool. Always check your salt level before adding salt to the pool even if this is your first time.
Prior use of liquid chlorine and tablets could have caused an increase in salt levels.
3
10,000 (38m )
3
12,000 (45m )
3
14,000 (53m )
3
16,000 (61m )
3
18,000 (68m )
3
20,000 (76m )
250 lbs/
(114 kg)
300 lbs/
(136 kg)
350 lbs/
(159 kg)
400 lbs/
(182 kg)
450 lbs/
(204 kg)
500 lbs/
(227 kg)
210 lbs/
(95 kg)
250 lbs/
(114 kg)
290 lbs/
(132 kg)
335 lbs/
(151 kg)
375 lbs/
(170 kg)
420 lbs/
(189 kg)
170 lbs/
(76 kg)
200 lbs/
(91 kg)
235 lbs/
(106 kg)
270 lbs/
(121 kg)
300 lbs/
(136 kg)
335 lbs/
(151 kg)
125 lbs/
(57 kg)
150 lbs/
(68 kg)
175 lbs/
(79 kg)
200 lbs/
(91 kg)
225 lbs/
(102 kg)
250 lbs/
(114 kg)
85 lbs/
(38 kg)
100 lbs/
(45 kg)
120 lbs/
(53 kg)
135 lbs/
(61 kg)
150 lbs/
(68 kg)
170 lbs/
(76 kg)
40 lbs/
(19 kg)
50 lbs/
(23 kg)
60 lbs/
(26 kg)
70 lbs/
(30 kg)
75 lbs/
(34 kg)
85 lbs/
(38 kg)
0
0
0
0
0
0
0
0
0
0
0
0
0 500 1000 1500 2000 2500 3000 3500
Pool Size in Gallons/
(Cubic Meters)
Salinity (ppm) measured in pool
6
After everything is setup, the display will show you a default screen with the current hours of operation per day. You may change this setting anytime by holding down the
for 3 seconds straight. The display will flash indicating it is now ready for time setting changes. In order to determine the proper chlorine timer setting for your pool, measure the
free chlorine level every couple of days during the first few weeks. Adjust the timer accordingly to achieve 1.0-3.0 PPM of Free Chlorine. It is advised to check the chlorine level
at least once a week to make sure the pool is properly sanitized. Weather, bather load, and sunlight have a major influence on the chlorine demand of the pool.
Note: If the pool has reached an undesirable amount of chlorine, it is recommended to unplug the Saltron power supply from the GFCI socket. Check chlorine levels each day
until the desired level is achieved. Plug the power supply back into the GFCI socket once the chlorine level is within the desired limit.
Compliments of www.poolsandstuff.com
To Next Page
Loading...
