sealed plumbing screw on the side.
Then, drill the collector’s rail with a 4,5mm bit and
secure with a sealed plumbing screw.
(54)
Put the left hand side corner in place and secure it to
the collector.
This step will be repeated for the right hand side corner
at the suitable time.
CAUTION:
THOSE PIECES SHOULD BE FIRMLY INSERTED
INTO THE RUNNER. IF NEEDED, A WOODEN
BATTEN OR A H
AMMER
CAN BE USED.
(55)
Then, start inserted the straight extension pieces
sideways into the runner. They should first fit the
corners of the pieces previously installed and the be
completely and firmly inserted into the collector’s
To Next Page
Loading...