Visit SSL at: www.solidstatelogic.com
© Solid State Logic E&OE March 2022
All rights reserved under International and Pan-American Copyright Conventions
SSL® and Solid State Logic® and CONNEX are ® registered trademarks of Solid State Logic.
No part of this publication may be reproduced in any form or by any means, whether mechanical or
electronic,without the written permission of Solid State Logic, Oxford, OX5 1RU, England. As research
and development is a continual process, Solid State Logic reserves the right to change the features and
specifications described herein without notice or obligation. Solid State Logic cannot be held responsible for any
loss or damage arising directly or indirectly from any error or omission in this manual.
PLEASE READ ALL INSTRUCTIONS, PAY SPECIAL HEED TO SAFETY WARNINGS.
Important Safety Notices
General Safety
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with dry cloth.
• Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including
amplifiers) that produce heat.
• Install in accordance with the manufacturer’s instructions.
• Only use attachments/accessories recommended by the manufacturer.
• Do NOT modify this unit, alterations may aect performance, safety and/or international compliance
standards.
• Ensure that no strain is placed on any cables connected to this apparatus. Ensure that all such cables are not
placed where they can be stepped on, pulled or tripped over.
• SSL does not accept liability for damage caused by maintenance, repair or modification by unauthorised
personnel. WARNING: To prevent possible hearing damage, do not listen at high volume levels for long periods.
As a guide to setting the volume level, check that you can still hear your own voice, when speaking normally
while listening with headphones.
EU Compliance
SSL CONNEX USB Microphone is UKCA & CE compliant. Note that any cables
supplied with SSL equipment may be fitted with ferrite rings at each end. This is to
comply with the current regulations and these ferrites should not be removed.
Electromagnetic Compatibility
EN 55032:2015, Environment: Class B, EN 55103-2:2009, Environments: E1 - E4.
Electrical Safety
Conforms to IEC 62368-1:2018 (3rd ed.), UL 62368-1:2019 (3rd ed) and EN IEC 62368-1:2020+A11:2020 (3rd ed)
To Next Page
Loading...
Need help?
General
