Solid State Logic CONNEX User Manual

RoHS notice
Solid State Logic complies with and this product conforms to European Union’s Directive 2011/65/EU on
Restrictions of Hazardous Substances (RoHS) as well as the following sections of California law which refer
to RoHS, namely sections 25214.10, 25214.10.2, and 58012, Health and Safety Code; Section 42475.2, Public
Resources Code.
Instructions for disposal of WEEE by users in the European Union
The symbol shown here, which is on the product or on its packaging, indicates that this
product must not be disposed of with other waste. Instead, it is the user’s responsibility
to dispose of their waste equipment by handing it over to a designated collection point
for recycling of waste electrical and electronic equipment. The separate collection and
recycling of your waste equipment at the time of disposal will help to conserve natural
resources and ensure that it is recycled in a manner that protects human health and the
environment. For more information about Safety Notices 24 CONNEX User Guide where you
can drop o your waste equipment for recycling, please contact your local city oce, your
household waste disposal service or where you purchased the product.
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
For USA – to the user
• Do not modify this unit! This product, when installed as indicated in the instructions contained in the
installation manual, meets FCC requirements.
• Important: This product satisfies FCC regulations when high quality shielded cables are used to connect
with other equipment. Failure to use high quality shielded cables or to follow the installation instructions
may cause magnetic interference with appliances such as radios and televisions and will void your FCC
authorisation to use this product in the USA.
• Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Compliance
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
Environmental
Evaluation of apparatus based on altitude not exceeding 2000m. There may be some potential safety
hazard if the apparatus is operated at altitude exceeding 2000m.
Evaluation of apparatus based on temperate climate conditions only. There may be some potential
safety hazard if the apparatus is operated in tropical climate conditions.
ATTENTION: Cancer and reproductive harm - www.P65Warnings.ca.gov
Temperature: Operating: +1 to 40ºC Storage: -20 to 50ºC

Solid State Logic CONNEX Specifications

General

Brand	Solid State Logic
Model	CONNEX
Category	Microphone
Language	English