SOLINTEG M Series - Country Code (Safety Code) Setting; Auto-Test

66
User Manual
MHT-25~50K series
※ 7.4CountCode(SafetyCode)Setting


Refer to “7.3 Advanced Setting” for more information.
※ 7.5 Auto-Test




button 3 seconds to check the test results.




Abbreviation Complete Name
 






 





＜







N-PE Check The N and PE shoing function on the BACK-UP side in the o-grid operation status.
CommsWatchDog
When the function is turned on, the inveer stops working when communication with
the master is lost.