To Next PageTo Next Page
Need help?Do you have a question about the SOLIS CREMA SL 70 and is the answer not in the manual?
General| Brand | SOLIS |
|---|---|
| Model | CREMA SL 70 |
| Category | Coffee Maker |
| Language | English |
Fill the water container with cold water up to 3 litres and press home firmly. Close the cover.
Pull out the required cord length and connect the appliance to an earthed socket.
Turn the main switch ON. The appliance must now be vented and rinsed out.
Place a container under the nozzle, turn knob, activate pump switch until water streams out.
Fit empty filter holder, place cup underneath, turn pump switch on until cup is full.
The appliance is ready when the temperature light shows green. Keep filter holder in place.
Fit the appropriate filter (one-cup or two-cup) into the filter holder.
Insert the filter holder into the brewing unit by moving from left to right and close tightly.
Place one or two cups on the tray under the filter holder. Adjust tray height if needed.
Activate the pump switch. Coffee will be poured. Turn off the switch when the cup is full.
Use the special portion-filter insert for 'hard' portion bags.
Use 1 or 2 cup filters for 'soft' SOLIS portions or other brand name portions.
Place cup under nozzle, turn knob and activate pump switch. Hot water runs automatically.
After pouring, close the rotary switch and turn off the pump switch.
Activate the steam switch and wait until the temperature light shows green.
Turn knob slightly to run out condensed water, then immerse steam jet in liquid to heat.
Turn the rotary switch off. Swing the steam nozzle back. Turn off the steam switch.
Turn steam switch off, turn knob, activate pump switch to vent/cool until steady stream.
Place cups on the storage plate to be kept warm by radiation.
Rinse cups with hot water from the hot water nozzle for quick heating.
Clean water container, drip tray, cup tray, filter holder, and filter inserts with hot water.
Remove coffee residues regularly and wipe with a damp cloth. Run hot water through.
Rinse filter inserts to keep them clean. Run pump with water through filter holder.
Clean the housing with a damp cloth and then rub dry with a cloth.
Decalcify regularly based on water hardness, at least every four to six months.
Use SOLIPOL, a product specially designed for decalcification.
Mix SOLIPOL with water, run through appliance, repeat, then rinse thoroughly with fresh water.
Check filter holder fitting, tightness, coffee residues on edge, or seal damage.
Check water container level and fitting; ensure coffee is not too old or coarsely ground.
Verify water, container fitting, coffee grind, steam setting, blockages, or venting.
Check coffee blend, grind, freshness, amount, tamping, cup temperature, or heating.
Use fresh coffee, store properly, grind to espresso grade, and use filtered water if needed.
Try SOLIS portions for consistent good coffee without frequent grounds cleaning.
SOLIS Aqua-Select water filter reduces hardness and prevents calcification.
SOLIS Solipol decalcifying agent for easy machine decalcification.
SOLIS storage box for keeping opened coffee packets and portions.
SOLIS grounds drawer for knocking out coffee grounds from the filter holder.
CAFÉ SOLIS coffee blends and portions offer exclusive, specially selected coffee.
