8.0 Pre-heating the cups
Apart from the type of blend and the
quality of the water, the most important
factor in making a good cup of coffee is
getting the right temperature.
8.1 Place your cups on the storage
plate to be kept warm (indirect hea-
ting by the radiation from the heating
system).
8.2 If you need to heat cups
quickly, you can rinse them out with
hot water from the hot water nozzle.
7.3 When no more steam is nee-
ded, turn the rotary switch off
again. Swing the steam nozzle back to
the cup tray or leave in an empty con-
tainer. Turn off the steam switch
7.4 With the steam switch off,
turn the rotary knob, activate the
pump switch again and allow the
appliance to vent/cool down until water
emerges from the nozzle in a steady
stream. Then, turn the rotary switch off
again.The appliance is now ready to
make coffee again.
IMPORTANT: After steam has been
used, the appliance must be vented
and allowed to cool (see also under
Point 3.4). The steam nozzle can beco-
me very hot. To prevent scalding, avoid
direct contact with the skin.
Note: We recommend that you clean
the steam nozzle immediately after use.
Otherwise, milk can leave residues
which are difficult to remove.
SOLIS CREMA SL 70
User’s manual
54
To Next Page
Loading...
Need help?
General
