FCAx3 USER MANUAL
2 +44 (1753) 214 500
Please read the following warnings to maintain the safe function and continued performance of your Sollatek
device.
INSTALLATION
The mounting of the unit must be in accordance with orientation as specied in this manual. The device must only be installed
and congured by trained and authorized staff.
TEMPERATURE
The Sollatek device must only be subjected to temperatures as specied in this manual.
VIBRATION AND IMPACT
The device MUST be installed in such a way as to be protected from impact in operation. Do not hit or drop the device.
NO SERVICEABLE PARTS
There are no serviceable parts inside the device. Do NOT open the housing.
VOLTAGES
The Sollatek device must only be connected to power supplies that comply with the acceptable voltage ranges as specied in
this manual.
VOLTAGE FLUCTUATIONS AND SURGES
The Sollatek device has surge protection as specied in this manual. Exposure to surge voltages outside these limits, or
excessively repeated surges within the limits may cause damage to the electrical circuits.
CURRENTS
Outputs should not be connected to short circuits or to loads that exceed the currents as specied in this manual. Care must be
taken to ensure that cables and terminations are safely terminated.
SEGREGATION OF POWER AND SIGNAL CABLING
Correct segregation of power and signal cabling must be followed. Do not run power and signal cables together in the same
conduit. Induction from power cables may corrupt data signals, leading to incorrect operation.
CONSEQUENTIAL FAILURES
The Sollatek device includes features to protect both itself and connected components. However, failure of connected
components may cause damage to the controller and/or connected components. Critical or vulnerable components should be
protected independently against failure.
FIT FOR PURPOSE
The Sollatek device must only be used for the purpose and functions described in this manual. As each application requires a
different conguration and setup, no liability is accepted by Sollatek UK Ltd for the correct operation of the nal equipment.
Failure to comply with the warnings may result in the device becoming damaged leading to
premature failure or unsafe operation. In extreme cases failure to comply may cause a risk
of electrocution or re.
To Next Page
Loading...
Need help?
General
