To Next PageTo Next Page
Need help?Do you have a question about the Sollatek FreoCom FCA23 Series and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Output Voltage | 230 VAC |
| Frequency | 50/60 Hz |
| Maximum Load Current | 23A |
| Storage Temperature | -40°C to +85°C |
| Cooling | Natural convection |
| Model | FCA23 Series |
| Efficiency | 98% |
| Humidity | 5% to 95% non-condensing |
| Protection | Over temperature |
| Certifications | CE |
Describes hazards associated with exposed live parts and high voltages.
Describes how the FCAx3 controls temperature using NTC probes and set cut-in/cut-out points.
Details the controller's defrost management functions, including natural and forced defrost.
Outlines built-in protection against voltage fluctuations, spikes, and surges for equipment safety.
Explains standard and advanced defrost modes, including pre- and post-defrost settings.
General warning about live terminals and the importance of disconnecting power before wiring.
Detailed instructions for connecting mains power and output loads to the FCAx3 terminals.
Guides on testing the basic temperature control operation of the FCAx3 using a Variac.
Procedures for testing the standard and manual defrost functions of the FCAx3 controller.
Steps to test the FCAx3's under-voltage and over-voltage protection features.
Explains how the FCAx3 detects and reacts to mains frequency deviations.
Details how the FCAx3 detects and handles faults with the primary temperature regulation probe.
Describes emergency defrost mode activation and operation when the defrost probe fails.
Overview of the desktop software for setting FCAx3 control parameters.
Details the window for adjusting specific FCAx3 operational parameters.
Guide on connecting the FCAx3 to a PC for configuration via the interface.
Instructions on how to program the SPP02 programmer device using the desktop interface.
Steps for transferring programmed configurations from the SPP02 to the FCAx3 unit.
Settings related to the number of outputs, probes, and door switch enablement.
Defines load types and operation modes for relays 2 and 3 under various conditions.
Parameters for setting temperature control, including probes, units, differential, and setpoints.
Configuration options for the energy-saving temperature setback feature.
Comprehensive settings for enabling and configuring defrost cycles, probes, and modes.
Settings to enable and configure over/under voltage protection and blind times.
