Preparing the equipment for use
ENGLISH 10
5.3 Shield installation
• Pull anti-vibration piece (2) with the bead
uppermost (towards the engine) over the shaft
tube. For this, the anti-vibration piece can be
bent open at the slot.
• Insert both square nuts (3) from the inside into
the contact shield.
• Secure shield (1) with both screws (4), both semi-
shells (5) and spacers (6) around the anti-
vibration piece on the shaft tube.
• Both factory-fitted gearbox screws (7) must grip
into the shield holes to safeguard its correct
position. This also prevents the shield from
slipping.
• Tighten screws (4) alternately and evenly.
Please note: No other mounting position is
acceptable for the shield!
5.4 Cutter installation
Always switch off the engine, pull the spark plug
cap and wear protective gloves when fitting or
replacing the cutter!
Subject to model, the brushcutter will be supplied
either with a grass cutter blade or with a nylon
head.
A) Fitting the grass cutter blade
(subject to model or as accessory)
• Position thrust piece (2) on gear shaft (1). Ensure
that the chamfered edge points towards the
gearbox.
• Position the grass cutter blade accurately on
collar washer (5) and push onto gear shaft (1).
• Position disc (6), fit spring washer (7) and lightly
secure locking nut (8). Please note: left-hand
thread! Fit the nut anti-clockwise.
• Lock the gear shaft; for this, insert assembly pin
(3) through the recess in winding protection (4).
• Slightly turn the gear shaft, until assembly pin (3)
catches in the recess of thrust piece (2).
• Tighten nut (8) (25 Nm). Please note: Left-hand
thread! Tighten the nut anti-clockwise.
Note: The thrust piece has been fitted incorrectly,
if the cutter can still be turned, even though the
nut has been tightened and the gear shaft has
been locked. In that case, repeat the assembly in
the correct manner.
• Remove assembly pin (3), and check the free
rotation of the grass cutter blade.
Fig. 5
Fig. 6
To Next Page
Loading...
