Solo evoCUT 4.0 - Page 30

SETTING THE WEEK PROGRAM
ENGLISH 10
10. SETTING THE WEEK PROGRAM
In the week program, the days of the week and the
times are set when the evoCUT 4.0 should mow
automatically.
In menu item 1 [All days], the evoCUT 4.0 mows at
the set times every day.
The symbol [X] shows the currently active day of
the week.
In menu item 2 [Day of week], the evoCUT 4.0
mows at the set times on the set day of the week.
x Use the corresponding [arrow key] (Fig. 3 - 3)
to select the required menu item and confirm
each one with the [multifunction key right].
Observe the mowing result and mow as long as
necessary in order to obtain a well-kept lawn.
[All days] menu item
x Select the [All days] menu item with the corresponding [arrow key] (Fig. 3 - 3) and confirm with the
[multifunction key right] (Fig. 3 - 5)).
x Press the [down arrow key] (Fig. 3 - 3) until [Change] is active.
x Select the required menu item with the corresponding [arrow key] (Fig. 3 - 3) and confirm with the
[multifunction key right] (Fig. 3 - 5).
Explanation of symbols
1)
Menu item
All days
2)
Menu item
Day of week
3)
[-]
Mowing window deactivated
[R]
Edge mowing
The evoCUT 4.0 mows on the right along the boundary able. After
mowing the edges, the evoCUT 4.0 continues mowing the marked-out
area.
[M]
Normal mowing
4)
Start time
The evoCUT 4.0 departs from the base station at the selected time for
mowing.
5)
End time
The evoCUT 4.0 moves back to the base station at the selected time.
6)
[0 - 9]
Fixed entry point
The evoCUT 4.0 departs from the selected entry point at the selected
time for mowing.
[?]
Automatic entry point
The entry points are changed automatically (recommended setting).
[ Week program ]
* All days [X]
Monday [X]
Back Change