ENGLISH 8
Lifting the clamp sliders loosens the straps again
Notice: Set the straps so that the backplate is
firmly and securely applied to the operator's back.
9. Fuel information
A high performance two-stroke engine operated
with a petrol:oil mixture (petrol + oil = fuel mixture)
or with a special fuel mixture for two-stroke
engines available from specialists powers this
machine.
We recommend the proprietary “Aspen 2-takt”
special fuel mixture. Please observe the special
fuel manufacturer’s instructions.
Information on individual mixing of the fuel mixture
The fuel mix must be formed from the following
components:
Lead-free regular petrol or lead-free super petrol
with a minimum octane number of 92 RON.
Branded 2-stroke engine oil corresponding to
the standard ISO-L-EGD or JASO FD
Recommendation:
Use the "SOLO Profi 2-stroke engine oil" at a
mixing ratio of oil:petrol of 1:50 (2 %).
Store the fuel mix no longer than 3 weeks.
Mix table for fuel mix:
Unsuitable petrol or deviations in the mixing ratio
may lead to serious engine damage!
Smoking or open flame is prohibited
Allow engine to cool before re-fuelling
Fuel may contain solvent-like substances.
Avoid skin and eye contact with mineral
products. Wear gloves while refueling.
Frequently change and clean protective
clothing. Do not inhale fuel vapors.
Do not spill fuel or oil. In case of spillage,
immediately wipe off mistblower. Do not allow
fuel mix to contact clothing. If fuel mix is spilled
on clothing, change clothing immediately.
Ensure fuel or oil do not contaminate soil
(environmental protection). Always use a
suitable protective soil cover.
Do not re-fuel in unventilated rooms. Fuel
vapors collect at ground level (danger of
explosion).
Transport and store fuel and oil only in
approved and clearly marked containers.
Children should have no access to fuel or oil.
Ensure you do not inhale exhaust fumes while
using the machine. The use of the motorized
mistblower is prohibited in closed rooms.
The handling of fuel requires caution and
consideration. It is imperative that all safety
instructions are observed! Only refuel when the
engine has been stopped!
Clean the area around filler inlet before
refueling.
Remove tank lid and fill fuel mix up to the lower
edge of the filler neck. Do not overfill. If
possible, always use a fuel funnel with filter.
Fill in card fully to avoid spilling of fuel or oil.
Replace and secure fuel tank lid.
10. Filling
When handling the spraying agents, always follow
the safety instructions of these operating
instructions (pay special attention to section 4.6)
and the information provided by the manufacturer
of the particular spraying agent.
Spraying agent volume:
Mix the spraying agents according to the
instructions provided by the manufacturer of the
spraying agent. Choose the appropriate volume
according to requirements.
Mixing spraying agents:
Only mix spraying agents out in the open. Never do
this inside living spaces, stables or in storage
spaces that are used for food or animal feed.
Never mix the spraying agent directly in the
spraying agent tank.
When using spraying agents that have been mixed
from herbal preparations, the liquid needs to be
pre-filtered.
Oil:petrol ratio = 1:50 (2 %)
Branded 2-stroke engine oil Petrol
20 ml 1 l
40 ml 2 l
100 ml 5 l
200 ml 10 l
Fig. 10
To Next Page
Loading...
