9
INSTALLATION INSTRUCTIONS
It’s recommended to use the washing machine on its own dedicated power
outlet for both convenience and safety. The power outlet must be grounded.
IMPORTANT!
If the power cord is damaged, it must be replaced by Residentia Group or one
of it’s authorised service representatives. Please contact 1300 11 HELP (4357) and
ensure the appliance is completely disconnected from the power supply.
WARNING!
• Stability is important to prevent the product from moving!
• Make sure that the product should not stand on the power cord.
Before installing the machine, the location must be:
1. Rigid, dry, and a level surface
2. Avoiding direct sunlight
3. Sufficient ventilation
4. Room temperature is above 0 °C
5. Kept far away from the heat resources such as coal or gas.
UNPACKING THE WASHING MACHINE
WARNING!
• Packaging material (e.g. Films, Styrofoam) can be dangerous for children.
• There is a risk of suffocation! Keep all packaging well away from children.
1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base packing.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
INSTALLATION OF THE CABINET BASE BOARD PEST PROTECTION
The cabinet base board that comes with your machine is an effective barrier
to keep mice, rats, and other pests from infestations. Although installation is
optional, we highly recommended installing this base board to avoid damage
to your machine's electronics.
WARNING!
The below instructions are advised to be performed by two people.
1. Carefully tilt the washer on a 45° angle
2. Insert the cabinet base board into the fittings located at the base
of the washing machine.
Installation
To Next Page
Loading...
Need help?
General
