SOMFY FREEVIA 600 User Manual (English)

Other manuals for SOMFY FREEVIA 600

Manual48 pages

Technical Data Sheet2 pages

Questions and Answers:

L
Lauren SmithAug 12, 2025
Why are my SOMFY Gate Opener motors not responding to the remote control commands?
- D
  Douglas PriceAug 12, 2025
  Several factors can cause your SOMFY Gate Opener motors to not respond to remote control commands: * The remote control range might be reduced due to a low battery. In this case, check the remote control battery. * The remote control range could also be reduced due to issues with the electronic unit's aerial. Check the wiring and position of the aerial. * Outside elements might be interfering with the radio signal. If this is the case, fit an external aerial. * The remote control may not be memorized. Memorize the remote control. * One or two motors might be unlocked. Lock the motors.
P
pbraunAug 16, 2025
What to do if the STATUS indicator of my SOMFY Gate Opener electronic unit is flashing with 3 pulses?
- A
  Anna PenaAug 16, 2025
  If the STATUS indicator on your SOMFY Gate Opener's electronic unit is flashing 3 times, it indicates a cell fault. This could be due to several reasons: * An obstacle blocking the cells. Remove any obstacles. * Misaligned cells. Correct their alignment. * Incorrectly wired cells. Wire the cells correctly. * Missing or disconnected cells. Check that your cells are correctly connected. If you have deliberately disconnected the cells and your gate is operating in auto close mode, you must deactivate auto close mode.
C
cruztimothyAug 20, 2025
What to do if the STATUS indicator of my SOMFY Gate Opener electronic unit is off?
- J
  Julie BryanAug 20, 2025
  If the STATUS indicator on your SOMFY Gate Opener's electronic unit is off, it means the motor is not powered. Check the power supply and the supply cable.
D
Deborah VargasAug 23, 2025
What does it mean when my SOMFY Gate Opener shows 5 pulses?
- J
  John KelleyAug 23, 2025
  If your SOMFY Gate Opener shows 5 pulses, it means the motor thermal protection device has been activated. Allow the motor to cool down until the STATUS indicator lights up continuously.
C
Carmen MullinsAug 27, 2025
What does it mean if my SOMFY Gate Opener shows 4 pulses?
- G
  Gabriela SilvaAug 27, 2025
  If your SOMFY Gate Opener displays 4 pulses, it indicates a short circuit on the electronic unit BUS output (terminals 3-4). Check the accessories connected to the electronic unit BUS output.
S
Stephanie LewisAug 30, 2025
What does it mean if my SOMFY Gate Opener shows 6 pulses?
- M
  Marcia FloresAug 30, 2025
  If your SOMFY Gate Opener displays 6 pulses, it indicates a short circuit on the electronic unit 24 V output (terminals 5-6). Check the accessory connected to the electronic unit 24 V output.
J
Jonathan LeeSep 3, 2025
Why does the automatic closing mode not activate on my SOMFY Gate Opener?
- T
  Taylor LaneSep 3, 2025
  The automatic closing mode on your SOMFY Gate Opener might not activate because photoelectric cells are not installed. Install some cells.
T
Travis SalinasSep 7, 2025
What to do if outdoor lighting is very low and the SOMFY Gate Opener motor is on standby?
- H
  Heather RivasSep 8, 2025
  If the outdoor lighting is very low and your SOMFY Gate Opener motor is on standby, increase the light around the electronic unit (using a torch, for example) if you want to make adjustments.