Need help?Do you have a question about the SOMFY Smoove origin io and is the answer not in the manual?
General| Power Supply | Battery |
|---|---|
| Dimensions | 80 x 80 x 10 mm |
| Color | White |
| Mounting | Wall-mounted |
| Battery type | CR2430 |
| Protection rating | IP30 |
| Compatibility | io-homecontrol |
| Radio frequency | 868 MHz |
| Operating temperature | 0°C to +60°C |
| Battery Life | 5 years |
Covers initial power connection and programming mode entry for motors.
Step-by-step guide to pairing a transmitter with the motor.
Procedure to verify and correct the motor's direction of rotation.
Instructions on how to reverse the motor's rotation direction.
Guides setting the upper limit position for the blind.
Defines the final upper travel limit for the blind.
Defines the final lower travel limit for the blind.
Verifies the programmed upper and lower limits of the blind.
Process for adding a new transmitter to the motor.
Step-by-step guide to fine-tuning the lower travel limit.
Step-by-step guide to fine-tuning the upper travel limit.
How to set a preferred 'My' position for non-tilting blinds.
How to set a preferred 'My' position for tilting blinds.
Programming the receiver using its own controls.
Steps to pair a transmitter with the RTS receiver.
Programming the receiver using a remote control.
Procedure to link a remote control to the receiver.
Process for pairing the initial transmitter with the receiver.
Configuring the receiver for different blind types.
Instructions to reverse the motor's rotation for the receiver.
Setting a preferred position for tilting blinds.
Setting a preferred position for roll-up blinds.
Steps to add a new transmitter to an existing system.
Instructions for replacing a lost or non-functional transmitter.
Step-by-step guide for programming RTS curtain track motors.
Specific programming steps for DCT motors.
Restoring WT motors to default factory settings.
Configuring receivers for use with external sun sensors.
Details on programming Sonesse 30 DCT for rotation and limits.
Restoring the Sonesse 30 DCT motor to factory default settings.
Steps for activating and programming the Thermosunis sensor.
Setting up the TaHoma® system and adding devices.
Process for adding compatible devices to the TaHoma® system.
Procedure to register the Connexoon device with the user's account.
To Next Page
