SOMFY INSTRUCTIONS
TELIS 4 SOLIRIS RTS
REMOTE CONTROLS
Part #’s
1810648 Telis 4 Soliris RTS Patio
my
Sun/Wind
Selector
Wind
Only
Sun
& Wind
5
1 2 3 4
Programming
Button
BACK
Four Channel
Telis
© Copyright Somfy Systems, Inc. 1/2010
1. With your current remote, select
the shade to operate by pressing
the Channel Selector Button. The
LED lights will illuminate each time
the Channel Selector Button is pressed
to show what channel is being
operated.
2. Using a paper clip, pen or similar device,
press and hold the Programming Button on
the back of the remote until your window
shade jogs up and down.
PROGRAMMING - ADDING A NEW REMOTE
4. Using a paper clip, pen or similar device,
press and hold the Programming Button
on the back. The window shade will jog.
This remote will now operate your shade
or awning.
3. Get the new remote and select
the new channel.
Programming
Button
Programming
Button
my
5
1 2 3 4
BACK
PAGE 1 REV5
PROGRAMMING - SETTING FAVORITE POSITION
1. Select the shade to operate by
pressing the Channel Selector Button.
The LED lights will illuminate each
time the Channel Selector Button is
pressed to show what channel is
being operated.
5
1 2 3 4
2. Using the up ( ) or down ( )
buttons, bring the shade or awning
to your favorite position, for example
halfway down or out. Press the
center ( ) button to stop movement
at the desired location.
BACK
Channel
Selector
LED Lights
my
5
1 2 3 4
Pen
Pen
Channel
Selector
LED Lights
my
5
1 2 3 4
my
Pen
my
4. To reach your favorite position,
press the center ( ) button
whenever the shade is already
stopped. The shade or awning
will automatically go to that
position.
3. Press and hold the center ( )
button until the window shade
jogs up and then down to record
the position.
my
5
1 2 3 4
5
1 2 3 4
C - 0019
To Next Page
Need help?
General
