General Information
Symbols
ATTENTION SYMBOL:
Important safety instructions!
To ensure the safety of personnel it is important to follow all
the instructions. Save these instructions!
IMPORTANT INFORMATION SYMBOL:
Information, useful advice!
Refers to a respective picture in the introduction or main text.
Safety instructions
General
• These installation and operating instructions must be read, understood
and complied with by persons who install, use or perform maintenance
on the operator.
• Keep this installation and operating manual accessible at all times.
• Installation, connection and initial commissioning of the operator may
only be carried out by technically knowledgeable persons.
• Install the operator on correctly aligned gates only. An improperly
aligned gate can cause serious injuries or damage the operator.
• The manufacturer assumes no liability for injuries, damage or break-
downs that occur due to non-compliance with the installation and
operating instructions.
• Always ensure compliance with accident prevention regulations and
current standards in each respective country.
• Take heed of and comply with the 'ASR A1.7 Technical Regulations
for Workplaces' of the committee for workplaces (ASTA). (Applies to
operators in Germany).
• Before any work on the operator disconnect it from the power supply
and lock it to prevent reconnection.
• Only use OEM (Original Equipment Manufacturer) spare parts,
accessories and mounting material.
Storage
• The operator must be stored in an enclosed, dry area at a room
temperature of –20 - +50 °C.
• The operator should be stored horizontally.
Operation
• The operator must be operated only if a non-hazardous force tolerance
is set or safety is guaranteed by other safety equipment. The force
tolerance must be set low enough to eliminate any danger of injury by
the closing force (see 'Maintenance and care').
• STArter:
No active safety contact strip on the main closing edge necessary.
Passive rubber prole edge sufcient.
• STArter+:
A active safety contact strip must be attached as a closing edge safety
device.
• Never put your hand near a gate when it is moving or near moving parts.
• Do not drive through the gate until it is fully open.
• There is a risk of persons being crushed or cut by the mechanism or
sharp edges of the gate.
• For automatic closing the main and auxiliary closing edges must be
secured in accordance with the applicable directives and standards.
• Open and close the gate only if there are no children, persons, animals
or objects within its area of movement.
• Regularly check the safety and protection functions and repair faults
when they are detected. See Care and maintenance.
Radio remote control
• The remote control must only be used for devices and systems in which
radio interference will not endanger people, animals or objects or the
risk is reduced by other safety devices.
• The user must be informed that the remote control of equipment that
presents a risk of accident may take place, if at all, only when there is
direct visual contact with the equipment.
• The radio remote control may only be used if the door’s movement
can be watched and no persons or objects are within the range of
movement.
• Store the handheld transmitter so that unintended operation, e.g.,
by children or animals, is impossible.
• The operator of the radio system is not protected from faults due to
other telecommunications equipment or devices (e.g. radio-controlled
systems that are licensed to operate in the same frequency range).
If substantial interference occurs, please contact your appropriate
telecommunications office which has radio interference measuring
equipment (radiolocation).
• Do not operate the handheld transmitter in areas with sensitive radio
communications or systems (e.g. airports, hospitals).
Type plate
• The type plate is attached to the inside of the base frame/housing.
The type plate shows the exact type drawing and the date of
manufacture (month/year) of the operator.
To Next Page
Loading...
