3
Symbols
CAUTION SYMBOL:
Important safety instructions!
To ensure personal safety, it is important to observe
all instructions. Save these instructions!
IMPORTANT INFORMATION SYMBOL:
Information, useful advice!
Refers to a respective picture in the introduction or main text.
Safety instructions
General
These installation and operating manual must be read, understood
and complied with by persons who install, use or perform maintenance
on the operator.
The manufacturer does not accept liability for damage or interruptions
to business resulting from non-observance of the installation and
operating manual.
Always ensure compliance with accident prevention regulations and
current standards in each respective country.
All applicable Directives and standards must be observed and complied
with for installation and operation, such as: EN 12453, EN 12604,
EN 12605.
Observe and comply with the “ASR A1.7 Technical Regulations
for Workplaces” of the German Committee for Workplaces (ASTA),
which is mandatory for the operator in Germany.
Before doing any work on the gate or operator, disconnect it from
the power supply and lock it to prevent reconnection.
Electrical wiring must be fi rmly secured to prevent displacement.
There is danger due to the crushing and shearing points presented
by the mechanism and the closing edges of the gate.
Never operate a damaged operator.
After installation and commissioning, all users must be instructed
in the function and operation of the swing gate operator.
Only use OEM (Original Equipment Manufacturer) spare parts,
accessories, and mounting material.
Storage
The operator must be stored in an enclosed, dry area at a room
temperature between –20 and +70 °C.
The operator should be stored horizontally.
+70°
20°
Operation
Do not allow children or persons who have not been instructed
to operate the gate control unit.
Open and close the gate only if there are no children, persons,
animals or objects within its area of movement.
Never put your hand near the gate when it is moving or near moving
parts.
Regularly check the safety and protection functions and repair faults
immediately. See Care and maintenance.
Do not drive through the gate until it is fully open.
Set the force tolerance as low as possible.
For automatic closing, secure the main and auxiliary closing edges
in accordance with the applicable directives and standards.
Remove the key to prevent unauthorised use.
Radio remote control
If a risk of injury could occur due to radio malfunctions on the
transmitter or radio receiver, use additional safety devices.
Only use the radio remote control when the range of movement
of the gate is visible and free of obstacles.
Store the transmitter so that it is protected from unintended operation,
e.g., by children or animals.
Do not use the radio remote control in areas with sensitive radio
communications or systems, e.g. airports or hospitals.
When signifi cant interference occurs due telecommunications
equipment, contact the responsible Telecommunications Offi ce which
has radio interference measuring equipment (radio location).
Type plate
The type plate is inside the cover of the control unit.
General Information
To Next Page
Loading...