SOMMER twist 200 E - Intended Use; Improper Use; Combined Operation

General Information
4
Intended use
IMPORTANT INFORMATION!
After installation of the operator, the person responsible
for the installation must complete an EC declaration of
conformity for the gate system in accordance with Machinery
Directive 2006/42/EC and apply the CE mark and a type plate.
This is also required for private installations and also
if the operator is retrofi tted to a manually operated gate.
This documentation and the installation and operating
manual are retained by the operator.
 The operator is designed exclusively for opening and closing one- and
two-leaf swing gate installations. Any other use does not constitute
intended use.
 The manufacturer accepts no liability resulting from use other than
intended use and the warranty expires. The user bears the sole
responsibility for any risk involved.
 The operator must be in good technical condition, and it must
be used for its intended purpose with awareness of the hazards.
Observe the installation and operating manual.
 Only operate the twist 200 E with DSTA-24 control unit.
 Only use the twist 200 E operator and DSTA-24 control unit in private,
non-industrial settings.
 Repair faults without delay.
 Only use operator on gates which comply with all valid standards
and directives: e.g. EN 12453, EN 12604, and EN 12605.
 Uphold safety distances between the gate leaf and the environment
in accordance with EN 12604.
 Only use stable and rigid gate leaves. Gate leaves must not bend
or twist when opening and closing.
 Ensure there is little play in the hinges of the gate leaf.
Improper use
 Opening or closing fl aps, e.g. for access to roofs or similar.
 Operation with 2x twist 200 E on one leaf is prohibited.
Combined operation
 1x twist 200 E and 1x twist XL or twist 350 mixed operation only
possible in connection with DTA-1 control unit and the “twist XS”
conversion set (3248V000).