Sonance DAB1 - REPEAT AND IR TOGGLE MACROS

44
DAB1 DISTRIBUTED AUDIO SYSTEM
You can edit an RS-232 command
after it has been dragged into the
M
ACRO Window by double-clicking or
right-clicking the command string. The
E
DIT RS-232 COMMAND window will
open. This allows changes to be made
to the individual RS-232 commands
without having to delete them and
replace them with new commands.
Figure 62 shows the EDIT RS-232
C
OMMAND window open, containing a
replacement macro command string.
Clicking the E
DIT RS-232 COMMAND
window’s OK button will replace the RS-
232 command string in the M
ACRO EDITOR
window with this new command string.
Stop Macro
The S
TOP MACRO command ( Figure 63 ) causes the macro to stop executing at the point where it is inserted. Under normal
circumstances the S
TOP MACRO command will not be needed, since macros automatically stop when they are finished. It is
intended to be used along with the S
TATUS TEST command (see page 42) to end a macro if a certain condition is met.
Repeat Steps
The R
EPEAT STEPS
command ( Figure
61
) lets you
repeat a particu-
lar macro com-
mand either until
the button is
released or for a
specific number
of times. This can
be useful when
controlling com-
ponents that
require certain
commands be
repeated to take
effect, or when issuing commands for buttons like volume controls, that can have continuous action.
Figure 62:
RS-232 M
ACRO EDITOR Window with RS-232 COMMAND EDIT Window Open
Drag
Icon Into
Macro
Window
Figure 63:
S
TOP MACRO Window
Set the
Number
of Repeats
Drag
Icon Into
Macro
Window
Figure 64:
R
EPEAT STEPS Window
Drag Command
into Repeat Bracket
Figure 65:
Drag Command Into Bracket