Sonance DAB1 - Programming a K2 Keypad to Activate Party Mode in a DAB1 System

56
DAB1 DISTRIBUTED AUDIO SYSTEM
Programming a K2 Keypad to
Activate P
ARTY MODE in a DAB1
System
Note: These instructions are for
using the Navigator Program
Manager software (included with
the K2 Keypad) to program the K2
keypad for Party Mode control of
a DAB1 system.
1. Launch the Navigator Control M anager
software. If you have already created a
System File for the system, open it. If
not, create a new System file that
includes a K2 keypad (see
Figure 79 ).
2. Select the M
ACRO E
DIT tool at the bottom
of the screen.
3. Click on the top S
OURCE button to program
it. This will open the M
ACRO EDITOR
window (see F igure 80 ).
4. Click on the S
ELECT NEW REMOTE button.
Find the IR codes for the Sonance
DAB1 and click “OK”. The M
ACRO
EDITOR window will return, with the
DAB1’s IR codes displayed in the IR
C
OMMAND window.
5. In the COMMAND TYPE drop-down box,
select B
UTTON TEST. Click the HELD-
D
OWN option and set the time to 1.5
seconds (see
Figure 81 , opposite).
Step 2. Select M ACRO E DIT Tool Step 3. Select Top S OURCE Button
Step 1.
Select
Keypad
Figure 79:
Programming a K2 Keypad for P
ARTY MODE, Steps 1 – 3
Figure 80: Programming a K2 Keypad for PARTY MODE, Step 4
Step 4. Click on S ELECT N EW R EMOTE
Button and find DAB1 IR Codes