57
DAB1 DISTRIBUTED AUDIO SYSTEM
6. Drag the macro icon into the Macro Window. This will establish a
button P
RESS-AND-HOLD condition (see
Figure 81
and
Figure 82
).
7. In the COMMAND TYPE drop-down box, select COMMAND FROM LIBRARY. The
DAB1 IR commands will reappear in the C
OMMAND window
(see
Figure 80
).
8. Drag the S
OURCE 1 command into the Macro Window, above the
Else
line, as shown in
Figure 82
.
9. Click on the S
OURCE 1 command you just dragged into the window. the
E
DIT I
NFRARED COMMAND window will appear (see
Figure 83
). Change the
M
INIMUM R
EPEATS to 6. Click OK.
10. Drag a second S
OURCE 1 command into the Macro Window, this time
below the
Else
line, as shown in
Figure 82
. Click OK.
Repeat Steps 3 – 10 for each K2 Source button being used in the system.
Now, a Source button P
RESS will activate the source in the zone the keypad
controls. A Source button P
RESS-
AND-HOLD
will activate the source in all
zones in the system (Party Mode).
Figure 81: Programming a K2 Keypad for
P
ARTY MODE, Steps 5 – 6
To Next Page
Loading...
