16
BEST PRACTICE
A 60 MICRON SANDING FILM IS RECOMMENDED FOR
FINAL SANDING.
16. Each successive coat should be thinner than the last.
The final coat should be a very light application (skim coat).
17. After final coat is applied and has dried, use a manual
pole sander or block sander on entire wall (do not use
a power sander). Wall surface should show no signs of
a speaker. If any defect is found, skim coat entire area,
and sand down again.
TOTAL MATERIAL OVER ACTIVE SURFACE OF
THE SPEAKER CAN NOT EXCEED 1/8
TH
OF AN
INCH (3mm).
IMPORTANT
FINISHING INSTRUCTIONS
To Next Page
Loading...
